1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

push plate id help

Discussion in 'Fisher Engineering Discussion' started by BBC co, Nov 29, 2012.

  1. BBC co

    BBC co PlowSite.com Addict
    Messages: 1,883

    have no clue what this is off of was told it would fit my 04 ram 1500 which took all of 2 seconds to figure out was wrong shame on the seller lesson learned on my part

    measures 33" from inside to inside of the uprights where holes are drilled
    33 1/2" measured to the outside of them so a 33" wide inside to inside of truck frame

    also rear facing horizontal angled pieces measure 12" from center to center of holes
    thanks for any input would like to sell these to some one and is impossible with out knowing what model they are

    [​IMG]
    [​IMG]
    [​IMG]
     
    Last edited: Nov 29, 2012
  2. Morrissey snow removal

    Morrissey snow removal PlowSite.com Addict
    Messages: 1,799

    never seen those before
     
  3. RepoMan207

    RepoMan207 PlowSite Fanatic
    from Maine
    Messages: 5,033

    Well, the Dodge part was right, but that's it. It's for 97-99 Dodge Dakota, part 7155