1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Old speedcast angle cyl. sizes??

Discussion in 'Truck & Equipment Repair' started by John T, Nov 26, 2013.

  1. John T

    John T Member
    Messages: 43

    I need to replace one angle cyl.

    When I measured the ram I come up with 1 1/2 x 14 ...

    but everywhere I look, I can only find 10" or 12"

    should I be measuring to the pin hole or the end of the ram?

    The body of the cylinder is 18"


    thanks.

    b.jpg
     
  2. John T

    John T Member
    Messages: 43

    Just went out and measured again...

    yep,
    13 1/4 to the pin hole.... and 14 1/4 to the end.... fully extended.

    anyone got a fisher part # ?
     
  3. John T

    John T Member
    Messages: 43

    OK
    I'll just go ahead and answer my own question for you watching at home...

    Turns out my measuring method was flawed...
    when measuring a cylinder, you measure from weld to weld on the body.

    ... basically you you are measuring how much of the ram (piston) fits inside the body.

    12" in my case.

    ordered 2 cylinders new hoses new quick connects... umm... oh, some super duper will never freeze up hydaulic fluid... and a bunch of new pins.
    supposed to be all in stock so....

    Mill supply.
     
  4. LON

    LON Senior Member
    Messages: 749

    20117K is the part number as well.