1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

no running or turn signals

Discussion in 'Fisher Engineering Discussion' started by Morrissey snow removal, Feb 12, 2013.

  1. Morrissey snow removal

    Morrissey snow removal PlowSite.com Addict
    Messages: 1,799

    no running or turn signals on a mm2 3 wire could it be the iso mod? its definatly the truck side tried 2 different plows
     
  2. dieselss

    dieselss PlowSite Fanatic
    Messages: 10,976

    did you ck the splices on the tk side first??? maybe the way they were hardwired wasnt proper and they corroded off???
    or yes, maybe your iso
     
  3. Morrissey snow removal

    Morrissey snow removal PlowSite.com Addict
    Messages: 1,799

    i put them on with heat shrink butt connectors but im am going to check
     
  4. dieselss

    dieselss PlowSite Fanatic
    Messages: 10,976

    Ok. Start there. Make sure you have signal going into the ISO,,,,,then out. Then to the gill connector. Then to plow lights. How's the gnds look in the lights as well?? Did you pull off the housing and look inside btw??
     
  5. Morrissey snow removal

    Morrissey snow removal PlowSite.com Addict
    Messages: 1,799

    i tried 3 different plows on the truck same thing no running or turn signals
     
  6. dieselss

    dieselss PlowSite Fanatic
    Messages: 10,976

    Ok. That's right I read that
    So back to your tk,,,ck wiring
     
  7. Morrissey snow removal

    Morrissey snow removal PlowSite.com Addict
    Messages: 1,799

    all fixed forgot there was fuses on the fisher harness
     
  8. dieselss

    dieselss PlowSite Fanatic
    Messages: 10,976

    Ok good deal