1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

no power to motor

Discussion in 'Truck & Equipment Repair' started by kepoo02, Mar 3, 2015.

  1. kepoo02

    kepoo02 Junior Member
    from wi
    Messages: 2

    I have an older western plow with the hydrolic pump. I have no power to motor. it works when jumped but will not work through the solenoid. new solenoid and new throttle. no fuse on this . help
     
  2. immortal.ben

    immortal.ben Member
    Messages: 65

    Check the ground. I am guessing when you jump it, you are grounding with the jumper cables?
     
  3. dieselss

    dieselss PlowSite Fanatic
    Messages: 10,973

    What version western is this?
     
  4. kepoo02

    kepoo02 Junior Member
    from wi
    Messages: 2

    it is an Isarmatic mark IIIA. yes with cables . will recheck the grounds thanks .
     
  5. dieselss

    dieselss PlowSite Fanatic
    Messages: 10,973

    The solenoid should have a positive jumper wire going to one of the small pins via the batt in wire. The other small pin is the signal ground via the controller.