1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

need truck side for snowex 1875

Discussion in 'Truck & Equipment Repair' started by snow7899, Sep 28, 2008.

  1. snow7899

    snow7899 Senior Member
    Messages: 238

    I need all the wiring and the controller for the truck side for a snowex 1875 sand pro. I went online and saw some prices that were out of control. Does anyone know of a source for these parts, at a reasonable price?????
     
  2. cretebaby

    cretebaby PlowSite Veteran
    Messages: 4,162

    i think you can just buy the box and the rest is just wire
     
  3. snow7899

    snow7899 Senior Member
    Messages: 238

    They used specialty connectors on both ends. Not a problem on the spreader side, but the connectors are part of the controller housing.
     
  4. Dstosh

    Dstosh Senior Member
    Messages: 534

    You dont want to just put it on a switch??
     
  5. snow7899

    snow7899 Senior Member
    Messages: 238

    I wanted to keep the motor speed adjustable and be able to operate the vib. The other problem is the weather proof connections at that amp draw. The only option I can think of would be the factory setup.
     
  6. Dstosh

    Dstosh Senior Member
    Messages: 534

    What we did was ran two wires, a positive and a negative and then took 4 pin trailer trailer plugs ( two sets ) One on spreader and one on truck harness. Then used a selnoid under the hood. Also wired the vibrator and spreader motor together.