1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Need new in cab controls

Discussion in 'Ice Management' started by jmarra, Jan 9, 2010.

  1. jmarra

    jmarra Junior Member
    Messages: 6

    anyone know a website i can view some new in cab controls for my gas sander
     
  2. threeleaf

    threeleaf Senior Member
    Messages: 227

    i have a in cab controler for an air flow gas job sander i never used it because the sander was smashed the first storm..it was installed in the truck and removed after totaling the truck..im not sure what they go for but its like new shoot me an offer..
    Allen
     
  3. jmarra

    jmarra Junior Member
    Messages: 6

    in cab control

    is it a 3 switch control box. (i.e. start, choke, spinner engager ??)
     
  4. threeleaf

    threeleaf Senior Member
    Messages: 227

    yes 3 switches its the newer one that is a thinner plastic molded box the only problem is we had to cut the factory end connector off but it will still work fine..
    giveme a call
    860 209 3844
    Allen
     
  5. jmarra

    jmarra Junior Member
    Messages: 6

    picture

    Hey Allen, just wondering if you had a chance to snap a picture of the in cab controller. When you get a chance send it to jmarra01@comcast.net. Thx Jimmy
     
  6. threeleaf

    threeleaf Senior Member
    Messages: 227

    jimmy
    sorry i havent had time to get it we have been real busy ill get it for yah tomorrow
    Allen
     
  7. plowking35

    plowking35 2000 Club Member
    from SE CT
    Messages: 2,923

    I have a controller from an ice o way if you need one.
    Converted to electric so I dont need it. Have the entire harness also back to the engine and weather pack connector.
    3 switch controller. off on start engine- idle choke -blast conveyor on
    Dino
     
  8. plowking35

    plowking35 2000 Club Member
    from SE CT
    Messages: 2,923

    Here is a pic of the control box

    spreader controls.jpg
     
  9. jmarra

    jmarra Junior Member
    Messages: 6

    in cab control

    how much are you asking for it?? and thanks for the reply
     
  10. plowking35

    plowking35 2000 Club Member
    from SE CT
    Messages: 2,923

    Please PM me or call me at 860.608.1842
    Dino
     
  11. cseutah

    cseutah Member
    from Utah
    Messages: 54

    i have almost the same controller as pictured for a sno way if you send a shipping tag ups, etc you can have it. i went to the smaller plastic low profile mounts for all mine and have never used this. i might even have 2 or 3 of them i'm sure the first few where like this and then after that they would order them with the other controller. i'll have the guys in the shop check around and find them. call me 435-994-0003 marty
     
  12. cretebaby

    cretebaby PlowSite Veteran
    Messages: 4,162

    What happened to the old one?

    You can make a controller with toggle switches pretty easily.
     
  13. dodgedump

    dodgedump Member
    from MASS
    Messages: 38

    Anyone know if this will work for a gas 2yd downeaster sander?