1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Need help

Discussion in 'Truck & Equipment Repair' started by pjslawncare, Jan 18, 2007.

  1. pjslawncare

    pjslawncare Member
    Messages: 32

    I just had to replace the base of my E47 and now she leaks from the joint between the power angle valve block assembly and the base just under the a selenoid. I will pull her apart again tomorrow and am hoping someone can shine some light as to what I may have messed up.
  2. B&B

    B&B PlowSite Fanatic
    Messages: 12,777

    Was the mating surface of the PA block clean or did it have some corrosion on it? The O-ring's need a clean flat surface to seal against. You did use new O-ring's right?
  3. pjslawncare

    pjslawncare Member
    Messages: 32

    All fixed, I got off easy as it was only the A selenoid was not tight. Duh :eek: