1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

MM2 slow left angle

Discussion in 'Fisher Engineering Discussion' started by ticki2, Jan 17, 2008.

  1. ticki2

    ticki2 Senior Member
    from NH
    Messages: 175

    I am about out of ideas on this one . Everything works great except left angle is very slow , you can hear the motor strain when in that position.What I've done so far ; replaced L and R poppet valves , old ones looked good , remove and clean L and R crossover check valves , remove clean and check solinoids , adjust three CV to spec.No change , what next ?
     
  2. killerrc51

    killerrc51 Junior Member
    from mass
    Messages: 7

    It Worked For Me

    Spred The Contacs On The Plug You Have To Use A Very Small Screwdriver But It Should Work.
     
  3. ticki2

    ticki2 Senior Member
    from NH
    Messages: 175

    Checked out all the electrical and everything was good . Finally found it , something in the valve block contaminated , everything good to go.Thanks for your response.