1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Meyer E-60

Discussion in 'Commercial Snow Removal' started by BIGWIV, Dec 6, 2003.

  1. BIGWIV

    BIGWIV Junior Member
    Messages: 26

    How does the motor come off the Meyer E-60? Friend's Meyer just stop working today got it down to the motor but can't get off. any help would be greatly welcomed!!:dizzy:
     
  2. Highpoint

    Highpoint Senior Member
    Messages: 241

    Very simple. Two small screws on bottom of motor (actually side it unit is still on truck. Imagine the motor being off and set on a table with the output shaft pointing up.)

    Take out these two phillips screws. This will only remove the cap. IF there is no rust inderneath. Than all you have to do is remove two more very long screws. Will proabably have a hex head. Motor should come right off. I'll be around if you have more questions.
     
  3. BIGWIV

    BIGWIV Junior Member
    Messages: 26

    HIGHPOINT

    THANKS!:waving: for responding so fast. We actually are already that far have the end cap off and the two thin bolts that are 4-5" long and still won't budge. Does it just slide out of the housing or does the whole thing come away from the pump? Thanks again
     
  4. Highpoint

    Highpoint Senior Member
    Messages: 241

    Entire motor should come right off base. Rust may be holding it. PRY! and keep me informed
     
  5. BIGWIV

    BIGWIV Junior Member
    Messages: 26

    HIGHPOINT

    We Got it !! Darn rust :gunsfiring: We were able to break it loose the motor is fried going to have to replace it. Thank-you for all the help Hope you make lots of payup this winter.


    Think Snow :drinkup:
     
  6. Highpoint

    Highpoint Senior Member
    Messages: 241

    Good deal. Hope the break down doesn't cost you some dough. Pull the motor in the spring and keep it and the pump inside a atmosphere controlled area. (if possible):nod: payup
     
  7. easthavenplower

    easthavenplower Senior Member
    Messages: 282

    ouch a new motor goes for about 1500
    sorry thats the price for pump and all
     
  8. Highpoint

    Highpoint Senior Member
    Messages: 241

    Motor will run around $150.00;)