1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Meyer e-47 won't angle left - need help.

Discussion in 'Truck & Equipment Repair' started by Jason Pallas, Feb 25, 2013.

  1. Jason Pallas

    Jason Pallas Senior Member
    Messages: 662

    My meyer e-47 won't angle back to the left. The motor runs and looks like it wants to angle back (shakes a little bit) but won't angle back. I replaced the C valve and coil - no change. I'm also pretty sure all couplers are in good working order. The electrical is also good.
    Here's one more bit of info - if I disconnect the hydro line to the right ram (the one that should push the plow left), there appears to be a lot of pressure in the line. If I hit the coupler against a flat surface to release the pressure (and also release the pressure in the ram - by tapping the ball/coupler with a hammer and an 3/8 extension), fluid squirts out and then the plow will sometimes angle back left.
    I've pretty much isolated this to EITHER the cross-over relief valve or the pilot piston. Any thoughts our input would be GREATLY appreciated. I don't want to just start replacing parts and hoping that I finally solve the problem. Anyone have any ideas? THANKS!
     
  2. wva

    wva Member
    Messages: 78

    if it works after you release the psi. in the coupler REPLACE the coupler with one that has a pin instead of ball. I have an E60 that does this and that the problem hope this helps