1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Md2 - Hooking up and releasing

Discussion in 'Meyer / Diamond Products Discussion' started by kootoomootoo, Nov 17, 2008.

  1. kootoomootoo

    kootoomootoo Senior Member
    Messages: 144

    Unless its involves a skid steer I am clueless here.

    What is the method to hook up the md2 to the mount.Ie i drive up to it then where do you go from there....has the 2 blue and 1 yellow pins.
  2. B&B

    B&B PlowSite Fanatic
    Messages: 12,777

    The yellows are only to remove just the blade/A-frame from the lift tower so your only concern is the blue pins.

    Once your drive into the plow (be sure to give it an extra shove with the truck when driving in) you then want to raise the plow a little with the jack...let the plow press up on the truck just a bit. And then just turn the blue pins until they snap into place. Sometime they will only snap in on one side if the ground is uneven. If thats the case lift the plow off the ground slightly and swing/push the plow around until the other two pin pop into place.

    Most of this is in the owners manual..and quite helpful. MDll owners manual