1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Looking for the DIY new cutting edge installation

Discussion in 'Boss Plows Discussion' started by WildRidge, Nov 10, 2007.

  1. WildRidge

    WildRidge Member
    Messages: 80

    Anybody remember the thread where a member listed step by step instructions on how to install the new cutting edges with the curb guards on an older model plow? I tried searching for it but had no luck.
  2. wild bill

    wild bill PlowSite.com Addict
    Messages: 1,239

    the cutting edge

    what are we talking rt 2 ? you will have to remove the center shoe and if it has 1/2 cutting edge bolt's on the blade now you will have to ream out the holes to 5/8 and you should not have any problems , if it's a rt 2 just function test it with somebody watching for clearance problems.
  3. SnoFarmer

    SnoFarmer PlowSite Fanatic
    from N,E. MN
    Messages: 7,921

    Yes, I did it, hear is the link to a pichttp://www.plowsite.com/showthread.php?t=37349&highlight=boss+edges
    You will need to trim a little off in the center of the edges to get them to fit as the center hinge is lower on the rtII.
    Last edited: Nov 10, 2007