1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

lift and angle cylenders

Discussion in 'Fisher Engineering Discussion' started by WOODY367, Mar 3, 2011.

  1. WOODY367

    WOODY367 Senior Member
    from LI, NY
    Messages: 458

    Are the lift and angle cylinders from a 8' conventional setup the same as a MM2? Being offered a set of NOS from a conventional but I have a MM2.
  2. sweetk30

    sweetk30 PlowSite.com Addict
    Messages: 1,588

    if i recall mm2 is oring seal. not pipe thread stuff,
  3. justme-

    justme- 2000 Club Member
    Messages: 2,138

    You can run either if you change the hoses- use teflon tape instead of pipe dope. I think the angle cylinders may be the same as the new ones I just got this season have a different looking port for the fitting with a flat area around it but worked fin for my pipe thread fittings.