1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Is a 7.6 Straight Standard Steel OK on an 06 Sierra 1500 ?

Discussion in 'Boss Plows Discussion' started by leadfooter, Aug 16, 2012.

  1. leadfooter

    leadfooter Member
    from Midwest
    Messages: 49

    Is a 7.6 Straight Standard Steel OK on an 06 Sierra 1500 ?
    Would I have to do anything to the front end?
    I am just doing my own driveway (100 yards) and the plow will come off for daily driving.
     
  2. BOSS_JG

    BOSS_JG Senior Member
    Messages: 194

    In most cases, the 7'6" Standard Duty Steel is recommended for the 1500 Sierra. I would recommend putting in your exact specs into the plow selector just to verify: http://www.bossplow.com/product-selector/truck-plow

    Hope this info helps you out!

    -Jodie
     
  3. leadfooter

    leadfooter Member
    from Midwest
    Messages: 49

    Thanks for the reply.
    I just bought one.
    I have a question. I was told that the all the valves and coils are all the same on this plow so if one goes down I could just swap them around. Is this correct or not ??
     
  4. BOSS_JG

    BOSS_JG Senior Member
    Messages: 194

    The only valves that are the same are the raise and lower valves. The coils are all the same.

    Thank you for purchasing a BOSS!
     
  5. 1 bad bolt

    1 bad bolt Member
    Messages: 71

    i had one on my 04 extended cab chevy 1500 and it did fine now have it on a 08 quad cab ram,