1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

I messed up... Plow now stuck in raised position

Discussion in 'Sno-Way Discussion' started by coostv, Dec 5, 2009.

  1. coostv

    coostv Junior Member
    Messages: 21

    I forgot to re-zip tie my controller cable on the plow side when I installed my 29 series and it is now pinched and will not turn on. Hopefully nothing is damaged other than the wire. Is there a way to set the plow down so I can repair or replace the wire?

    Thanks,

    Chris
     
  2. wizardsr

    wizardsr PlowSite.com Addict
    Messages: 1,557

    Open the hydraulic fitting on the lift ram...
     
  3. coostv

    coostv Junior Member
    Messages: 21

    Right after I posted I thought of that so I did it. Thanks for the reply. I did a temporary solder fix and will have to pick up some supplies to do a permanent repair.

    It did not take me long to figure out what happened. I remembered almost immediately what I had forgotten to do...

    Lesson learned. Thanks again.