1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Help!! installing gauges!

Discussion in 'Ram Trucks' started by GMC99, May 3, 2004.

  1. GMC99

    GMC99 Senior Member
    from 60188
    Messages: 753

    I just bought a 3 pod gauge setup for my 2003 ram cummins, and I need some help on how to install the sending unit for the gauges. I ordered a trans temp gauge, boost, and exhaust temp gauges. Can anyone tell me how to install the sending units?? Any help PLEASE!!
  2. Alec

    Alec Junior Member
    Messages: 3

    Check out www.dieseltruckresource.com, both the tech FAQ's and 3rd gen forum. I could give you a run down of the general procedure, but I have a fist gen truck, so the specific locations are a little different. Plus, there are some choices . . .

    It isn't too hard to install any of them. Good luck,

  3. m&m owner

    m&m owner Member
    from MN
    Messages: 33

    I have installed a boost guage and exaust temp on a 1993 and a 2002 not to hard. I was just nervous drilling into the exaust manifold.