1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

fisher mm1 blade exchange angle issues

Discussion in 'Fisher Engineering Discussion' started by isaiahcasey, Oct 18, 2015.

  1. isaiahcasey

    isaiahcasey Junior Member
    Messages: 5

    my old blade was worn out had rust holes in it so i found a blade dirt cheap. put it on and on the bottem giude plate has angle irn then a peice of steel welded to make a triangle back up. but two issues. the blade dosnt angle half way cause it hits thatr steel. thats one problem. the other is the pistons are bout bottemed out. so can i cut the bottem peice of the fram to make it go further? and do they make shorter pistons so the pistons are bottemed out or should i reinforce the back of blade and move the pistns further out? please help!
     
  2. dieselss

    dieselss PlowSite Fanatic
    Messages: 10,957

    I think pictures would be needed for this one.
     
  3. isaiahcasey

    isaiahcasey Junior Member
    Messages: 5

    ok i will try to get some pics to help