1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Fisher M/M problem

Discussion in 'Truck & Equipment Repair' started by 1plownut, Dec 18, 2009.

  1. 1plownut

    1plownut Junior Member
    Messages: 6

    My fisher is only going right motor and pump will run but not move.I un hooked hoses manually moved left hooked up and in went right back to rightside again.Can't find any freyed/sliced/crossed wires.Any help would be great thanks
     
  2. no lead

    no lead PlowSite.com Addict
    Messages: 1,308

    s3 valve stuck shifted. maybe s2 stuck.
     
  3. mansf123

    mansf123 Senior Member
    from mass
    Messages: 817

    bad fish stic
     
  4. mcwlandscaping

    mcwlandscaping 2000 Club Member
    Messages: 2,557

    Definitely stuck valve, have had the same thing happen to me,

    Remove each and put 12v to each and cycle them a few times until they clean themselves out and you should be set! Be sure to change your fluid if you haven't already this season!
     
  5. 1plownut

    1plownut Junior Member
    Messages: 6

    Thanks for the help.Already tried different controller the other night. I'll try the valves tommorrow i assume i just hook 12v to where wire normally goes and ground solonoid
     
  6. 1plownut

    1plownut Junior Member
    Messages: 6

    Took valves out cycled a few timess put back in still nothing. Getting 12v to #2 but 1.5v or less at #1 and #2 no matter left or right.Pump runs in all directions up,left,right but still only move right.