1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Fabricate a Chassis mount

Discussion in 'Meyer / Diamond Products Discussion' started by gafred, Nov 8, 2011.

  1. gafred

    gafred Member
    from Boone
    Messages: 36

    Hey Guys, I need to fab a chassis mount for a 1993 F350 4x4 for a meyer classic.
    What is the vertical spread between the A frame pin to the lift frame tube?
     
  2. Dubl0Vert

    Dubl0Vert Senior Member
    Messages: 178

    The distance between those two points does not matter much, your chain can adjust for the height difference. What is important is that you make sure your clevis mounting point is 10-12 inches off the ground. Any higher and when you angle your plow it will not be flat on the ground, one end will be kept off the ground because you A frame will not sit level. Good Luck!!
     
  3. Dubl0Vert

    Dubl0Vert Senior Member
    Messages: 178

  4. gafred

    gafred Member
    from Boone
    Messages: 36

    thanks for the info helps me in the right direction..
     
  5. gafred

    gafred Member
    from Boone
    Messages: 36

    Ok still trying to piece this together,,, please post pics of side mounts for the Meyer 17095 frame mount kit, 92-98 Ford F350 4x4, if you can.

    Thanks,
    Fred