1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

E60 pressure check set-up

Discussion in 'Meyer / Diamond Products Discussion' started by MKC, Dec 5, 2012.

  1. MKC

    MKC Junior Member
    Messages: 14

    Does anyone have a picture or diagram to share on how to hook up pressure tester to check pressure on E-60's. Or an explanation of how to hook it all up, steps to take, etc....thanks!
  2. jasonv

    jasonv PlowSite.com Addict
    from kannada
    Messages: 1,114

    Use a 1/4" NPT tee, 2F+1M, and a 1/4" NPT pressure gauge that reads thousands of PSI. I think it should be something like 2500 psi, so figure a gauge that reads at least 5000 PSI, maybe 10000. Just plumb that gauge in to one of the angle lines. Set your relief valve low (unscrew) to start. Have someone hold the switch to pressurize that line, and tighten the relief valve until it reads the specified PSI, then lock it down.