1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

E47-How hard it is to replace this seal?

Discussion in 'Commercial Snow Removal' started by shadowmaker1969, Jan 9, 2004.

  1. shadowmaker1969

    shadowmaker1969 Junior Member
    from va
    Messages: 17

    It s one on top of the pump itself, where the shaft raises the arm. I think its #31 on the pump picture. Its bubbling air. Looks like it just unbolts and pops out. But I wanted to make sure before I tore into it and screwed up something else. DId a search and didnt find anything.

    Brad
     
  2. Big Nate's Plowing

    Big Nate's Plowing PlowSite.com Addict
    Messages: 1,266

    you can change it in about 3-4 minutes, it is easy to do
     
  3. stackitslamit

    stackitslamit Junior Member
    Messages: 9

    very easy repair. first pry old seal out with a small screw driver or something similar, then put new seal on the ram. We use a socket that is big enough to go over the ram to tap the seal down evenly. if you dont get it right the first time youll have the same problem with the new seal.