1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

E-57 rebuild kit

Discussion in 'Meyer / Diamond Products Discussion' started by KartAnimal29, Sep 19, 2011.

  1. KartAnimal29

    KartAnimal29 PlowSite.com Addict
    from Ct.
    Messages: 1,482

    Can the average Joe do a rebuild on the E-57 pump? Or is it a PITA
     
  2. kimber750

    kimber750 PlowSite Veteran
    Messages: 3,638

    They are not hard to rebuild, just have to pay close attention to where everything goes. Hardest part I feel to put back together is the crossover valve. The other issue is I am guessing you dont have a test stand. So you will need to rig up a gauge to set the pressure after you rebuild. E57 is basically a E47 with a bigger motor. You can get the repair manuals from Meyers sight.
     
  3. JCByrd24

    JCByrd24 Senior Member
    from Maine
    Messages: 232

    Definitely doable by the average handyman...try the Smith Brother's site (link below) for incredible knowledge on these units. Much better than Meyer's manual. Also, you don't necessarily need to take the entire thing apart to "rebuild" (such as crossover as mentioned above). Usually the problem of a non-functioning unit will become evident very quickly once you develop an understanding of how the unit works. and just taking the tank/ram off 3 main valves out and letting drain upside down for a while will get out the bad fluid.

    http://www.smithbrothersservices.com/meyer_E-47-pump-rebuild.html
     
  4. NickT

    NickT Senior Member
    Messages: 707

    Smith brothers is a good site, also the meyer repair manuals have diagrams and pictures good luck.