Snow Plowing Forum banner

Cutting Edge

2K views 5 replies 2 participants last post by  Antlerart06 
#1 ·
What Cutting Edge Do you guys suggest.Steel,Poly,Rubber.I have a Western 9'.Thanks In Advance.
 
#2 ·
What are you plowing that will be the ???

My self I run Steel 5/8'' x 8'' on my western plows and even on my boss plow
 
#4 ·
AFSPLOWING;1657058 said:
Right Now Just Residential But i will be taking on a few smaller commercial accounts that are friends of mine.
If you are plowing stamp driveways or pavers then you better go with rubber or poly
 
#6 ·
AFSPLOWING;1657086 said:
Thanks for the info, who has the best price
I don't know I make all my Cutting edges. I can build them for half of what one cost and last just as long as a factory edge
I make them out of 5/8'' x 8'' plate steel and on the ends I double it up on the ends. Im over 1'' thick on the ends.

One my 8.5 pro pls was put on 12-2011 and it still has 3.5'' of wear life
My MPV was put on same time and I am replacing it only has 1'' wear left.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top