1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

bleeding a meyer

Discussion in 'Commercial Snow Removal' started by nofearpi, Dec 13, 2003.

  1. nofearpi

    nofearpi Junior Member
    Messages: 26

    i guess i have air in my system. it will go up and down but it is stuck left. i took the skid off and i cannot move the cylinders at all. any suggestions?
     
  2. J HIsch

    J HIsch Member
    Messages: 66

    Stuck left

    Are you using a Meyer controller or aftermarket controller?

    SOmetime on aftermarket controls, they can get hooked up backwards. If that is not the case. check your fluid, if you did that move plow side to side while in up position. to get fluid into rams. Then recheck fluid. If that doesnt help. I am lost too.
     
  3. shadowmaker1969

    shadowmaker1969 Junior Member
    from va
    Messages: 17

    Check your C solenoid. Its a common problem. Make sure the coil is energizing also. Have someone hit the switch while you hold a screwdriver or pocket knife over the coil. If it becomes magnetized, you know the coil is working.

    Mine is stuck now also, believe it was low fluid on mine though.


    Brad