1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Bad angle block?

Discussion in 'Meyer / Diamond Products Discussion' started by cpd427, Dec 8, 2010.

  1. cpd427

    cpd427 Member
    from ohio
    Messages: 34

    Is this angle block shot? It dosen't leak any fluid while no pressure is going through it, but not sure if it will with pressure.

    [​IMG]
     
  2. Nasty-Z

    Nasty-Z Senior Member
    Messages: 370

    Has the unit been used like that already ? I have seen them corroded much worse than that and still function fine.

    I say give it a shot , what do you have to loose except some O rings an a bit of fluid.

    TOM
     
  3. cpd427

    cpd427 Member
    from ohio
    Messages: 34

    This E47 hasn't been used in a long time, so im not to sure. The pump was given to me, so i'll prob just give it a try.
     
  4. B&B

    B&B PlowSite Fanatic
    Messages: 12,777

    Should be fine but check the mating side for flatness before installing it to save yourself a little effort ahead of time.