1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

angleing of snow plow

Discussion in 'Truck & Equipment Repair' started by firepi57, Dec 29, 2009.

  1. firepi57

    firepi57 Junior Member
    from maine
    Messages: 5

    hello can any one help me out with my question i have notice the my dimond snow plow while plowing seems to angle a little while plowing straight or back dragging how to i correct this problem my email is firepi57@hotmail.com thank you
     
  2. Crash935

    Crash935 2000 Club Member
    Messages: 2,377

    Bad O-rings on valves, cross over relief set to low.
     
  3. firepi57

    firepi57 Junior Member
    from maine
    Messages: 5

    ok thank you ill check that out also i just check my oil level in my mail cylinder put in almost a quart of oil is that a possible to maybe
     
  4. dchr

    dchr Senior Member
    Messages: 159

    Oh it may have something to do with it-just a hunch:jester:
     
  5. Crash935

    Crash935 2000 Club Member
    Messages: 2,377

    Try bleeding the cylinders then if it was that low. Air trapped in the cylinders will allow it to angle some.
     
  6. firepi57

    firepi57 Junior Member
    from maine
    Messages: 5

    ok i will try that thanks expecting a big storm this weeking here in northern maine so kinda of need it work thanks again