|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||||||
|
#1
11-09-2012, 07:22 PM
|
|||
|
|||
|
Fluid Film & Electrical Problems....Fluke??
I have a 98 Dodge Ram 2500. I recently purchased a case of Fluid Film and coated the whole underside of my truck and let it dry for a day. When I took the truck out the next day, the speedo didn't work and the check engine light came on, turns out it was a bad speed sensor which is located on the rear axle.After it was replaced I took it for a spin and noticed the trans temp guage wasn't working. It turns out it was a bad sending unit on the pan. Would Fluid Film have any effect on these components or was it just a fluke?
|
|
#2
11-12-2012, 06:00 PM
|
|||
|
|||
|
They were due to fail. FF on electrical components all the time and no issues.
__________________
Jerre Heyer SIMA MEMBER SIMA.org online questions and answers F350 X-cab V10 W/ 810 or 8611LP BLIZZARD Or a 7'4"-8'6" Rad Snow blower hanging out front
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
