older Fisher Ford push plates on 84 F250 ?

[hugger94]

I am attempting to remove the pushplates from my f250 I am starting to scrap out. I have gotten all of the bolts loose for the visible portion of the pushplates but the angled brace going back up to the frame appears to be meeting the upper frame flange just behind the front crossover frame behind the front wheels.

My question is I assume there are more bolts fastening this support brace to the frame? How many and are they also tied to the crossover? I have never seen one of these fisher plow mounts so I am very inexperienced at what I should be looking for. These angle supports are very sturdy and don't move any.

Any information will be greatly appreciated.

hugger94

[hugger94]

I found a .pdf diagram of the mounting push plates for the Ford F250 on the Fisher website. The right and left support brackets have a welded bolt attached through the frame side directly behind the shock bracket. The welded bolt has a 1 1/8 inch nut which with an impact wrench should loosen the nut.

http://www.fisherplows.com/pdf/6240_071890.pdf

hugger94