View Full Version : fisher plows
09-07-2005, 05:48 PM
hi all, last march i bought a 02 ford f350 dual wheel ,with a 9ft fisher, i noticed that the plow does not lift much off the ground, i had a meyer before,with a e60 h and that thing lifted the plow up onto my hood if i wanted it too... i liked to fact that my old meyer would do that i could stack snow really good, this fisher cant stack that high, is there anything i could do to make it lift higher??? in the lifted position if i remember right its about 6 inches off the ground, i dont think its right... thanks
09-07-2005, 06:17 PM
this may sound like a silly question, but have you checked the chain? can it be adjusted higher?
09-07-2005, 07:56 PM
lumps , it hits the stops on the plow frame,, ive never seen a plow ride so low
09-07-2005, 08:13 PM
Are you running any ballast in the bed behind the axel? A thousand pounds or so would lift the front end up a bit.
09-07-2005, 08:29 PM
The ballast will definately help. I run a 9' Fisher on my '00 F-250 and it does ride a bit low, but it's in the same position when it's on my '01-F550. Keep in mind that you have a 9' blade, and when angled, the trailing edge will be closer to the ground than with an 8' blade.
09-07-2005, 08:30 PM
i have a 2 yrd sander in the back, its a one ton dump...
09-07-2005, 08:34 PM
plowed, your right, a plow does sit lower angled, but should it still be that low straight?? im just not sure, maybe im used to the meyers?
09-07-2005, 09:20 PM
Where in CT are you? Maybe we can take a look and see. One thing you can look at is your A-frame. Which one of the three holes is it in? Mine was in the middle hole, but I changed it. I moved it up to the lower hole, it's still pretty close to level - gives it a little better angle of attack, and I noticed right away that it doesn't lift as high as it bottoms out sooner on the bump stops. This may be something for you to look at...
09-12-2005, 08:20 PM
Sounds more like the suspension is sagging than a plow issue to me.
vBulletin® v3.8.6, Copyright ©2000-2013, Jelsoft Enterprises Ltd.