View Full Version : Snow ex error codes
12-06-2011, 01:34 PM
Hi I just hooked up my snowex 8500 today and the controller is flashing and beeping a L6 code. I have never seen this code before. does anyone know what it means. thanks.
12-08-2011, 10:28 PM
Its Lb or low battery. Check your connections.
12-19-2011, 10:50 PM
I was hooking up my spreader today and getting a error code of E-3 does any body know what this is. When I turn the switch the spinner will spin and then stop a couple of seconds later then give me a error code, can only help me out Chris@lotstriper.com
12-20-2011, 10:34 AM
Sorry the error code is E0 flashes on the sprinner and auger controls, can anyone tell me what this means, thanks Chris@lotstriper.com 610.496.7403
12-29-2011, 11:36 AM
Chris, is the motor plugged in when you turn the control box on? EO usually means that it is not completing the circuit. Everthing needs to be connected. I had the same problem.. if you go to snowex website you can download all the manuals you need plus troubleshooting guides. Hope this helps. Also make sure there are around 11-12 volts going to the control box and motor.
vBulletin® v3.8.6, Copyright ©2000-2016, Jelsoft Enterprises Ltd.