mud_man93
06-02-2003, 09:58 PM
my 99 Tacoma went to the shop 3 weeks ago to have the transmission fixed(i was backing up and the whole truck started jerking) they replaced the tranny with a rebuilt one ever since then when i give it gas or shift slowly it makes a clunk almost like the u joints are gone so i took it to the dealer to have them check it out after 2.5 hours and two techs they came to the conclusion that the transfer case and the rear diff are shot and then they told me that my warranty was void because the truck has been beat the only reason that i can see that they could say that is i hit a rock pulling out fire wood and it bent the skid plat. i don't think it is the transfer case and and diff because it worked fine before they fixed the tranny.
also they put a new rack and pinion in it and on the tie rod end they didn't put the cotter pin in the nut and it rattled lose i noticed it and pulled over on the side of the road and tightened it up when i went to leave i was stuck in the soft sand so i went to put it in 4x4 and the hub that the dealer just "fixed" would not budge so trying to get out i slid down the slope still couldn't get out so i had to get towed out i put cotter pins in and when i went to the dealer and told them what happened the service manager said I'm quoting him "i don't see why you had to pull over your steering still worked" because of the tie rod not being tight and the hub not working it riped the steering boots and snapped off the plastic bumper mounts all they said about it was sorry :realmad: :realmad: what do any of you think it could be something in the tranny or is it the diff and transfer case sorry for the long post this is really p!@@^%g me off thanks
also they put a new rack and pinion in it and on the tie rod end they didn't put the cotter pin in the nut and it rattled lose i noticed it and pulled over on the side of the road and tightened it up when i went to leave i was stuck in the soft sand so i went to put it in 4x4 and the hub that the dealer just "fixed" would not budge so trying to get out i slid down the slope still couldn't get out so i had to get towed out i put cotter pins in and when i went to the dealer and told them what happened the service manager said I'm quoting him "i don't see why you had to pull over your steering still worked" because of the tie rod not being tight and the hub not working it riped the steering boots and snapped off the plastic bumper mounts all they said about it was sorry :realmad: :realmad: what do any of you think it could be something in the tranny or is it the diff and transfer case sorry for the long post this is really p!@@^%g me off thanks